Using The Factory Settings - Siemens SINAMICS G120 Operating Instructions Manual
Frequency converter
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
6.3
Using the factory settings
You only have to do the following, if the factory settings of the converter match your motor
and your application.
1. Connect the converter in accordance with the wiring example. See Section: Wiring
2. If you operate the drive on a fieldbus, you have to do the following:
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
examples for the factory settings (Page 53)
– Configure your central controller according to the settings of the converter.
– If required by the fieldbus, set the bus address on the converter. See also Section:
Interfaces, connectors, switches, terminal blocks and LEDs of the converter (Page 42)
Basic commissioning
6.3 Using the factory settings
59
Advertisement
Chapters
Table of Contents
