hit counter script
  1. Manuals
  2. Brands
  3. Ultratec Manuals
  4. Fog Machine
  5. IceJet III
  6. Operator's manual

Ultratec IceJet III Operator's Manual

Hide thumbs

Advertisement

Table of Contents

IceJet III
Operator's Manual
www.ultratecfx.com
VER. 24.08.18

Advertisement

Table of Contents
loading

Related Manuals for Ultratec IceJet III

Summary of Contents for Ultratec IceJet III

  • Page 1 IceJet III Operator’s Manual www.ultratecfx.com VER. 24.08.18...

  • Page 2: Table Of Contents

    Table of Contents Warning ..................3 Safety Precautions ..............3 Technical Specifications ............. 4 Operating Procedure ..............5 CO2 Data ..................6 Warranty ..................7 Contact Information ..............7 Note: Please read entire manual before operating the IceJet III www.ultratecfx.com...

  • Page 3: Warning

    Warning Important Safety Instructions: 1. Do not remove the outer case. 2. Ensure that this unit is grounded at all times. Failure to do so may result in serious injury. 3. High pressure gas dangers. Safety Precautions 1. Ensure that any operation of the machine is supervised by suitably trained and authorized personnel. 2.

  • Page 4: Technical Specifications

    Technical Specifications Model: IceJet III Part Number: CLF-2149 120 Volt 50/60 Hz. CLF-2151 220-240 Volt 50/60 Hz. Length: 6 in 15 cm Width: 6.5 in 16.5 cm Height: 10.4 in 26.5 cm Net Weight: 6 lbs 13 kg Power Rating: 120 Volt A.C.

  • Page 5: Operating Procedure

    Operating Procedure 1. Before operating the IceJet a site review is required. As the IceJet is capable if dispensing large quantities of Co2 in a room the air exchange properties of the room must be determined. (See sample calculation below) Due to the nature of the Dewar tank (low pressure system) some Co2 is consumed to keep the liquid Co2 cold.

  • Page 6: Co2 Data

    CO2 Data 1 pound = 8.741 (scf) gas 1 pound = 0.118 (gal) liquid Specific gravity = 1.53 for gas Air has 21% oxygen. CO2 is heavier than air and will sink to lower areas and displace the air. OSHA exposure 0.5% for 8 hours (TWA) or 3% for 15 minutes (STEL) Things to watch for when using CO2 are the reduction of the oxygen content and the collecting of CO2 in low or confined spaces.

  • Page 7: Warranty

    RA number clearly marked on the outside of the box. Warning: Ultratec Special Effects considers all of it’s product to be safe for use in the application it was intended. Ultratec Special Effects takes no responsibility for misuse or incorrect use. Always refer to the Product Manual for proper use.

This manual is also suitable for:

Clf-2149Clf-2151

Table of Contents