Installation; Fitting The Iop To The Control Unit - Siemens Sinamics G120 Operating Instructions Manual
Radio wall transmitters intelligent operator panel
Hide thumbs
Also See for Sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Installation
3.1
Fitting the IOP
Fitting the IOP to the Control Unit
IOP power supply
The IOP has no internal power supply and derives its power directly from the Control Unit of
the Inverter through the RS232 interface. The IOP can also be connected to a PC and
derives its power through the USB connection.
To fit the IOP to the Inverter Control Unit the following procedure should be performed:
1. Place the bottom edge of the IOP casing into the lower recess of the Control Unit
2. Push the IOP forward until the top fastening clicks into place on the Control Unit housing.
Figure 3-1
Fitting the IOP to the Control Unit
Intelligent Operator Panel (IOP)
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
CAUTION
housing.
3
15
Hide quick links:
Advertisement
Table of Contents
