IBM TotalStorage DS300 Best Practices Manual page 603

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

[device_list] [start | stop]

device_list]

[local_device_list]

[foreign] [spare]

device (See Device manage device commands)

identify [device_list] [start | stop]

Identify one or more devices by blinking their LED.

The default action is to start the LED blinking and return to the prompt. The LED

will stop blinking after about 30 seconds or when a device identify stop or

array identify stop command is given for that device.

To identify all of the disks in an array, use the array identify command.

info [device_list]

Output information about some or all devices. (You can specify which devices by

entering a parameter for device_list.)

This command is identical to the device manage device info command (see

Device manage device commands) when only one device is specified.

initialize [local_device_list]

Remove all array membership information for the local devices in

local_device_list.

list [foreign] [spare]

List the known physical and/or spare devices. All devices are listed if no

parameters are specified.

List any devices which have not been allocated to an array volume.

Appendix A. Command line interface reference

Totalstorage ds400