Specifications - IBM TotalStorage DS300 Hardware Installation And User's Manual
Hide thumbs
Also See for TotalStorage DS300:
- Best practices manual (680 pages) ,
- Hardware installation and user's manual (110 pages) ,
- Quick installation manual (13 pages)
Table of Contents
Advertisement
Specifications
The following information is a summary of the specifications of the storage
subsystem. Depending on the storage subsystem model, some specifications might
not apply.
Table 1. DS300 and DS400 storage subsystems operating specifications
Size (measured from front of hard disk
drive to rear of unit)
v Depth: 584 mm (23.0 in.)
v Height: 128 mm (5.0 in)
v Width: 442 mm (17.4 in)
Heat output
v 558 watts (1903.96 Btu/hr)
Weight
v Standard storage server as shipped
(without hard disk drives): 48.2 kg
(106 lb)
v Standard storage server as shipped
(with 14 hard disk drives): 62.2 kg
(137 lb)
v Unit weight (without hard disk drives):
25.9 kg (57 lb)
v Unit weight (with hard disk drives):
39 kg (86 lb)
Electrical input
v Sine-wave input (50 to 60 Hz) is
required
v Input voltage:
– Low range:
- Minimum: 90 V ac
- Maximum: 136 V ac
– High range:
- Minimum: 198 V ac
- Maximum: 264 V ac
– Approximate input kilovolt-amperes
(kVA):
- Minimum configuration: 0.06 kVA
- Maximum configuration: 0.56 kVA
4
Hardware Installation and User's Guide
Environment
v Air temperature:
– Storage server on:
10° to 35°C
(50° to 95°F)
Altitude: 0 to 914 m (3000 ft)
– Storage server on:
10° to 32°C
(50° to 90°F)
Altitude: 914 m (3000 ft) to 2133 m
(7000 ft)
v Humidity:
– 8% to 80%
Acoustical noise emissions:
For maximum system configurations (14
hard disk drives installed).
v Sound power (operating): 5.7 bels
(typical)
v Sound pressure (operating): 42 dBA
(typical)
Note: These levels were measured in
controlled acoustical environments
according to the procedures specified by
the American National Standards Institute
(ANSI) S12.10 and ISO 7779 and are
reported in accordance with ISO 9296.
Actual sound-pressure levels in a given
location might exceed the average values
stated because of room reflections and
other nearby noise sources. The declared
sound-power levels indicate an upper limit,
below which a large number of computers
will operate
Advertisement
Table of Contents
