Table of Contents
Advertisement
Figure 33. Node Numbering for an SP System
3.5.2 Procedure to Get the Jack Number
Following are the steps required to get the jack number:
1. From the SP control workstation, determine the dependent node's number
by entering
output that looks like the following:
# SDRGetObjects DependentNode node_number
node_number
#
2. From the SP CWS, determine the switch_node_number by entering
SDRGetObjects DependentNode node_number==n switch_node_number,
is the node_number of the dependent node you just got from the previous
command. This gives the following output:
# SDRGetObjects DependentNode node_number==4 switch_node_number
switch_node_number
#
3. From the SP CWS, determine the host name of the SP Switch primary
node by entering
this:
31
15
16
29
13
14
27
11
12
25
9
10
23
8
7
21
5
6
3
4
19
17
1
2
Switch 2
Switch 1
Frame 1
Frame 2
SDRGetObjects DependentNode node_number.
4
3
splstdata -s | grep -p primary
47
61
45
43
57
41
39
53
37
35
49
33
Switch 3
Frame 3
Frame 4
This produces
. The output looks like
Installation and Configuration
where n
84
Advertisement
Table of Contents
