Table of Contents
Advertisement
Updated April 2, 2009
Chapter 2. Installation instructions
Unpacking the printer . . . . . . . . . . . . . . . . . . . . . . 18
Installing a SureMark printer . . . . . . . . . . . . . . . . . . . . 18
Using the wall mounting feature. . . . . . . . . . . . . . . . . . . 23
USB selection . . . . . . . . . . . . . . . . . . . . . . . . . 31
Before installing an IBM SureMark printer, be sure to read "Electronic emission
notices" on page 205.
Note: For translations of these safety notices, see IBM Safety Information-Read
© Copyright IBM Corp. 1997, 2006
Installing for EIA-232/RS-485 communication . . . . . . . . . . . . . 18
Installing SureMark for USB communication . . . . . . . . . . . . . 21
. . . . . . . . . . . . . . . . . . . . . . . 24
Installing fillers for EIA-232/RS-485 printers . . . . . . . . . . . . . 24
Installing fillers for USB printers. . . . . . . . . . . . . . . . . . 26
Baud rate selection . . . . . . . . . . . . . . . . . . . . . . 28
EIA-232 communications protocol selection . . . . . . . . . . . . . 28
DTR/DSR control . . . . . . . . . . . . . . . . . . . . . . 29
XON/XOFF control . . . . . . . . . . . . . . . . . . . . . 29
Baud rate selection . . . . . . . . . . . . . . . . . . . . . . 30
EIA-232 communications protocol selection . . . . . . . . . . . . . 30
DTR/DSR control . . . . . . . . . . . . . . . . . . . . . . 30
XON/XOFF control . . . . . . . . . . . . . . . . . . . . . 30
DANGER
To avoid a shock hazard, do not connect or disconnect any cables
or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
DANGER
To avoid shock hazard:
The power cord must be connected to a properly wired and
earthed receptacle.
Any equipment to which this product will be attached must also
be connected to properly wired receptacles.
This First, GA27-4004.
. . . . . . . . . . . . . . . . . . . . 31
17
Advertisement
Table of Contents
