Table of Contents
Advertisement
Updated April 2, 2009
Set or cancel unidirectional printing
EIA-232 Syntax:
where:
Default:
Remarks:
Request document length for landscape print
EIA-232 Syntax:
Purpose
Remarks
Set document length for landscape print
EIA-232 syntax:
Remarks
Note: There are 50 motor steps per inch. A 6-inch document = 300 steps. (Use
ESC U n or X'1B55;n'
n=00
Cancels unidirectional printing
n=01
Sets unidirectional printing
n = 00
This is valid in the document station in portrait mode only, when there must
be two passes of the print head to print one print line.
Example: double-high or emphasized print.
When unidirectional mode is set to double-high characters, it takes three
passes of the print head.
In bidirectional mode, printing double-high characters takes only two passes
of the print head.
Unidirectional printing takes longer but increases the quality of the print.
GS N X'02' NULL or X'1D;4E;02;00'
To determine the length of the document in the Landscape Print station
v Not supported on printer Models TI1 and TI2.
v Document length data is sent in status bytes 9 and 10.
v Status byte 5, bit 3, is sent to indicate that extra data (beyond status byte
8) is attached.
GS c 1 n where n = 2 bytes indicating the length of the document in print
motor steps.
v Not supported on printer Models TI1 and TI2.
v Document length data is sent in status bytes 9 and 10.
v Status byte 5, bit 3, is sent to indicate that extra data (beyond status byte
8) is attached.
295 to allow a margin for error; n=0x127.) To calculate the number of dots
per printed line:
v for 150 DPI (dots per inch)
[(motor_steps - 75 * 3.12] - 10 = dots per line
v or for a 6-inch document
Appendix D. EIA-232 programming information
133
Advertisement
Table of Contents
