Remote Management Setup - IBM BladeCenter Installation And User Manual
4-port gb ethernet switch module
Hide thumbs
Also See for BladeCenter:
- Installation manual (82 pages) ,
- User manual (78 pages) ,
- Manual (43 pages)
Table of Contents
Advertisement
The information on the window is described as follows:
MAC Address
VID
Type
Port Map
Remote Management Setup
This section includes: Management Station IP Settings, SNMP Community
Settings, Setup Trap Receivers, Setup User Accounts, and Serial Port
Settings, as well secondary windows.
The following information pertains to the windows illustrated in "Management
Station IP Settings" on page 58, "SNMP Community Settings" on page 58, and
"Setting up trap receivers" on page 58.
Note: Some of the described data fields only appear on some of these windows.
v A trap receiving station is a device that constantly runs a network management
v The information on these windows is described as follows:
The MAC address from which packets will be statically filtered.
The VLAN ID number of the VLAN to which the MAC address belongs.
Select the filter type, Permanent or DeleteOnReset.
You can designate the port on which the MAC address resides.
application to receive and store traps. You can enter up to four entries.
IP Address
The IP address of the trap receiving station. If necessary, consult your
system network administrator to obtain this IP address.
Community String
A user-defined SNMP community name. This community string will be
included on SNMP packets sent to and from the switch. Any station that
is not a member of this community will not receive the packet.
Rights
Enables each community to be separately set to either Read (read-only),
meaning that the community member can only view switch settings or
R/W (read/write), which enables the member to change settings in the
switch.
Chapter 5. Web-Based network management
57
Advertisement
Table of Contents
Troubleshooting
