Table of Contents
Advertisement
Cleaning the door glass panels
Clean the door glass panels thoroughly with a solution of water and
washing up liquid. Then dry them carefully
Putting the door glass panels back.
1. From above insert the door glass
panels at an angle into the door
profile at the bottom edge of the
door one after the other and lower
them.
3
Insert the smaller panel first, then
the larger panel.
2. Take hold of the door trim (B) at
each side, position it on the inside
edge of the door and plug the door
trim (B) into the upper edge of the
door
3
On the open side of the door
trim (B) there is a guide bar (C). This
must be pushedThis must be pushed
between the outer door panel and
the guide corner (D).
The clip seal (E) must be snapped in.
55
Advertisement
Table of Contents
