Table of Contents
Advertisement
Adjusting Power Saver
To adjust the Power Saver setting:
1
Make sure the printer is on and Ready appears on the display.
2
Press
on the operator panel.
3
Press
until
4
Press
until
5
Press
until
6
Using the numeric pad or the right and left arrows on the operator panel, enter the number of minutes for the
printer to wait before entering Power Saver.
The settings available range from 2–240 minutes. If you want to turn Power Saver off, see Disabling Power Saver
on page 106.
7
Press
.
Submitting Selection appears.
Note: You can also adjust the Power Saver setting by issuing a Printer Job Language (PJL) command.
Disabling Power Saver
Disabling Power Saver is a two step process. First, you must turn the variable on, and then select the variable. To disable
Power Saver:
1
Turn the printer off.
2
Press and hold
3
Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4
Press
until
5
Press
until
Submitting Selection appears.
The operator panel returns to Energy Conserve.
6
Press
until
Resetting the Printer appears briefly followed by a clock. The operator panel then returns to Ready.
7
Make sure Ready appears.
8
Press
on the operator panel.
9
Press
until
10
Press
until
11
Press
until
12
Use either the numeric keypad or the right and left arrows to enter 0 (zero). Disabled appears, and then press
.
Submitting Selection appears. Power Saver is now disabled.
Administrative support
Settings appears, and then press
Setup Menu appears, and then press
Power Saver appears, and then press
and
while turning the printer on.
Energy Conserve appears, and then press
Off appears, and then press
Exit Config Menus appears, and then press
Settings appears, and then press
Setup Menu appears, and then press
Power Saver appears, and then press
Adjusting Power Saver
.
.
.
.
.
.
.
.
.
106
Advertisement
Table of Contents
