Table of Contents
Advertisement
13. Click Finish to reboot.
14. The driver is installed when Windows reboots.
To install USB support
If you have installed Windows 95 OSR 2.x and you wish to use USB, you will need to
install USB support. These drivers are located on the Recovery CD in
\HP\DRIVERS\W95\USB.
1. Copy the \HP\DRIVERS\W95\USB directory and its contents from the Recovery CD
to C:\WINDOWS\TEMP.
2. Open the MS-DOS Prompt.
3. Type: CD \WINDOWS\TEMP\USB and press Enter.
4. Type: ATTRIB -R *.* /S and press Enter.
5. Type: OEMUSB /Q:1 /T:C:\WINDOWS\TEMP\USB\USB1 /N:E and press Enter.
6. Type: USBUPD2 /Q:1 /T:C:\WINDOWS\TEMP\USB\USB2 /N:E and press Enter.
7. From Control Panel, double-click System, then click Device Manager.
8. Remove the "PCI Universal Serial Bus" device under Other Devices. Click OK in the
Confirm Device Removal dialog box.
9. Click on Refresh to redetect the USB Controller.
10. Click Next to search for the driver.
11. Click Other locations to search for the driver.
12. Browse to C:\WINDOWS\TEMP\USB\USB1 and click OK.
13. Click OK.
14. Click Finish to restart the HP Notebook. The driver loads when Windows reboots.
To install accessory module hot swap support (Agate Tioman)
If you've installed a retail version of Windows, you can install software that will allow
accessory modules to be changed in the unit without rebooting. This software must be
installed manually.
Using Windows 95
Installing Windows 95
Corporate Evaluator's Guide
123
Advertisement
Table of Contents
Troubleshooting
