Table of Contents
Advertisement
Left-side cover
To remove the left-side cover of the tower model:
1. Review the information in "Before you begin" on page 47.
2. If you are planning to install or remove any part other than a hot-swap hard
disk drive or hot-swap power supply, turn off the server and all attached
devices, and disconnect all external cables and power cords.
Statement 1:
DANGER
Electrical current from power, telephone, and communication cables is hazardous. To
avoid a shock hazard:
v Do not connect or disconnect any cables or perform installation, maintenance, or
reconfiguration of this product during an electrical storm.
v Connect all power cords to a properly wired and grounded electrical outlet.
v Connect to properly wired outlets any equipment that will be attached to this product.
v When possible, use one hand only to connect or disconnect signal cables.
v Never turn on any equipment when there is evidence of fire, water, or structural
damage.
v Disconnect the attached power cords, telecommunications systems, networks, and
modems before you open the device covers, unless instructed otherwise in the
installation and configuration procedures.
v Connect and disconnect cables as described in the following table when installing,
moving, or opening covers on this product or attached devices.
Cover
release
lever
Installing options
49
Advertisement
Table of Contents
