Media-Cable Tray - IBM 8677 - BladeCenter Rack-mountable - Power Supply Hardware Maintenance Manual And Troubleshooting Manual
Hardware maintenance manual
Hide thumbs
Also See for 8677 - BladeCenter Rack-mountable - Power Supply:
- Installation and user manual (104 pages) ,
- Installation and user manual (72 pages) ,
- Planning and installation manual (126 pages)
Table of Contents
Advertisement
7. Unscrew the captive thumbscrews at the bottom corners of the chassis, and pull
8. Pull the SPC chassis out until it stops (about half-way out).
9. While supporting the SPC chassis with your hands, press the release levers on
To reinstall the SPC chassis, reverse the previous steps.
Media-cable tray
Note: The media cable is only present in BladeCenter unit models that have a
media tray with a diskette drive.
The media-cable tray is between the media tray and the SPC chassis.
Complete the following steps to remove the media cable tray.
Note:
v Read "Installation guidelines" on page 31.
v Read the safety notices at "Safety information" on page 85.
v Read "Handling electrostatic discharge-sensitive devices" on page 88.
1. Remove the BladeCenter bezel.
2. Push the tabs on the left and right sides of the tray to the left and right
Shipping
bracket
SPC chassis
thumbscrews
SPC chassis
thumbscrews
a. To disengage the shipping brackets, slide the shipping brackets towards the
blowers.
them until the SPC chassis moves out about 1.27 cm (0.5 inches).
the sides, and pull the SPC chassis out of the BladeCenter unit. Place the SPC
chassis on a strong, flat surface.
a. Press the release pads at the bottom corners of the bezel.
b. Swing the bezel up and off the BladeCenter.
respectively; then, pull the media tray out of the BladeCenter.
Release
latch
Chapter 5. Service replaceable units
53
Advertisement
Table of Contents
