Table of Contents
Advertisement
When you run the ServeRAID Manager program from the startable IBM ServeRAID
Support CD, you are using Startable CD mode, in which you can configure your
controller before you install your operating system.
To run the ServeRAID Manager program in Startable CD mode, turn on the server;
then, insert the IBM ServeRAID Support CD into the CD-ROM drive. If the
ServeRAID Manager program detects an unconfigured controller and ready drives,
the program automatically starts the Configuration wizard, and a window similar to
that shown in Figure 1 opens.
Figure 1. Configuration wizard window
Configuring the controller
You can use the Configuration wizard to configure your controller. The Configuration
wizard provides two configuration options: Express and Custom. Express
configuration automatically configures your controller, and you can use Custom
configuration to configure your controller manually.
Note: If the integrated RAID controller has two channels, it will appear in the
ServeRAID Manager tree as two controller objects. However, you can configure
only one array and one RAID level-1 logical drive.
Using Express configuration
Express configuration automatically configures your controller, creates an array by
grouping together the first two physical drives that appear in the ServeRAID
Manager tree, and it creates a RAID level-1 logical drive.
Complete the following steps to use Express configuration:
1. In the ServeRAID Manager tree, click the controller.
2. Click Express configuration.
14
xSeries 345 Type 8670: Hardware Maintenance Manual and Troubleshooting Guide
Advertisement
Table of Contents
Troubleshooting
