Table of Contents
Advertisement
•
Find the emergency power-off (EPO) switch, disconnect switch, or electrical outlet in the room.
If an electrical accident occurs, you can quickly turn off the switch or unplug the power cord.
•
Do not work alone under hazardous conditions, or near equipment that has hazardous voltages.
•
Disconnect all power before:
— Performing a mechanical inspection
— Working near power supplies
— Removing or installing main units
•
Before you start to work on the machine, unplug the power cord. If you cannot unplug it, ask the
customer to power-off the wall box (that supplies power to the machine) and to lock the wall box
in the off position.
•
If you need to work on a machine that has exposed electrical circuits, observe the following
precautions:
— Ensure that another person, familiar with the power-off controls, is near you. Remember:
another person must be there to switch off the power, if necessary.
— Use only one hand when working with powered-on electrical equipment; keep the other
hand in your pocket or behind your back.
— Remember: There must be a complete circuit to cause electrical shock. By observing the
above rule, you may prevent a current from passing through your body.
•
When using testers, set controls correctly and use the approved probe leads and accessories for
that tester.
•
Stand on suitable rubber mats (obtained locally, if necessary) to insulate you from grounds such
as metal floor strips and machine frames.
•
Observe the special safety precautions when you work with very high voltages; these
instructions are in the safety sections of the maintenance information. Use extreme care when
measuring high voltages.
•
Regularly inspect and maintain your electrical hand tools for safe operational condition.
•
Do not use worn or broken tools and testers.
•
Never assume that power has been disconnected from a circuit. First, check that it has been
powered-off.
•
Always look carefully for possible hazards in your work area. Examples of these hazards are
moist floors, nongrounded power extension cables, power surges, and missing safety grounds.
•
Do not touch live electrical circuits with the reflective surface of a plastic dental inspection
mirror. The surface is conductive; such touching can cause personal injury and machine damage.
•
When the power is on and power supply units, blowers and fans are removed from their normal
operating position in a machine, do not attempt to service the units. This practice ensures correct
grounding of the units.
•
If an electrical accident occurs, use caution:
— Switch power off
— Send another person to get help/medical aid
ix
Advertisement
Table of Contents
