Advertisement
5. Maintenance & Adjustments
5.5 Feed/Reverse Pressure Adjustment
The upper table rear was screwed by captive screws. To remove, please loosening the captive screws
about 5mm first and then lift the end side of rear side up and slide it out.
Feed Pressure Adjustment
The machine is already well set for proper feeding pressure. However, according to different strap
characteristics (such as smoother surface or different thickness), some adjustments for feeding
pressure are still necessary. If short feed problem happens a lot, and it is a result of improper feeding
pressure, please do the following adjustments:
Loosen Nut B and turn Nut A clockwise to increase the feeding pressure. Or loosen Nut A and turn
Nut B counterclockwise to decrease the feeding pressure. After adjustments, be sure to tighten these
2 Nuts well.
A
- 28 -
Advertisement
