Safety notes
2.7 Canadian Installations only: Industry Canada (IC) rules
2.7
Canadian Installations only: Industry Canada (IC) rules
• This device shall be installed and operated in a completely enclosed container to prevent
RF emission, which otherwise can interfere with aeronautical navigation. Installation shall
be done by trained installers, in strict compliance with the manufacturer's instructions.
• The use of this device is on a 'no-protection non-interference' basis.
– The user shall accept operations of high powered radar in the same frequency band,
– The user is responsible for removing, at the user's expense, any device found to
Improper device modifications
Risk to personnel, system and environment can result from modifications to the device,
particularly in hazardous areas.
• Only carry out modifications that are described in the instructions for the device. Failure
Due to the large number of possible applications, each detail of the described device versions
for each possible scenario during commissioning, operation, maintenance or operation in
systems cannot be considered in the instructions. If you need additional information not
covered by these instructions, contact your local Siemens office or company representative.
Note
Operation under special ambient conditions
We highly recommend that you contact your Siemens representative or our application
department before you operate the device under special ambient conditions as can be
encountered in nuclear power plants or when the device is used for research and
development purposes.
12
which may interfere with or damage this device.
interfere with primary licensing operations.
WARNING
to observe this requirement cancels the manufacturer's warranty and the product
approvals.
Compact Operating Instructions, 10/2021, A5E32007360-AB
SITRANS LR460