Smartgrid; Machine Parameters; Suds Cooling; Water Intake - Miele PWM 908 Operating And Installation Instructions
Hide thumbs
Also See for PWM 908:
- Operating and installation instructions (104 pages) ,
- Operating and installation instructions (100 pages) ,
- Operating and installation instructions (100 pages)
Table of Contents
Advertisement
Supervisor level
SmartGrid
The
SmartGrid
setting (available
depending on country) is only visible if
a Wi-Fi network is set up and
activated. This function can be used
for starting your washing machine
automatically at a time when your
energy supplier's energy costs are
most economical.
Activating
SmartGrid
sensor a new function. Use the "Timer"
sensor to set SmartStart. The washing
machine will then start within the
timeframe specified by you when it
receives a signal from your energy
supplier. If it has not received a signal
from the energy supplier by the latest
start time set, the washing machine will
start automatically.
Factory setting: Off
96
gives the Timer
Machine parameters
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a
programme with a temperature of 70°C
or higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes are rated
less than 70°C.
Factory setting: On
Water intake
Pre-wash
You can select the type of water for
the pre-wash.
– cold
Only cold water is used for the pre-
wash.
– hot
Hot water is also added for the pre-
wash.
Hot water can only be added if the
wash temperature is above 30°C.
Main wash
You can select the type of water for
the main wash.
– cold
- Quick Links:
- A Fault Message Appears in the...
Hide quick links:
Advertisement
Table of Contents
