Advertisement
7. Maintenance
ALWAYS TURN OFF AND DISCONNECT POWER SOURCE BEFORE
PERFORMING MAINTENANCE TO THE MACHINE. ALLOW SUFFICIENT
HEATER COOLING TIME (APPROX. 5 MINUTES) TO AVOID BURNS.
1.1 Cleaning and Lubrication
The high reliability and long service life of the strapping machine will depend on regular cleaning and
maintenance.
Note: All the critical strap transportation components, such as drive rollers and the strap guides, must
be kept free of oil and grease (lubricant).
Lubricant must be non-resinous and conform to SAE 30 standards.
1.2 Maintenance
Note: Only use original spare parts supplied by the manufacturer.
Daily Maintenance
Use an air gun to clean the following parts daily; cutters, strap guide and accumulating feed rollers
Air
Air
Air
Air
Weekly Maintenance
Lubricate front bar, press bar, rear bar and shafts within the arch on a weekly basis. Please refer to the
following mesh areas for instruction.
Before lubricating, be sure to clean the parts first to avoid mixing oil and debris which may have a
negative effect on the machine function.
- 34 -
Advertisement
