Establishing The Connection To The Connectivity Module - Siemens SIMOTICS CONNECT 400 Operating Instructions Manual
Connectivity module
Hide thumbs
Also See for SIMOTICS CONNECT 400:
- Operating instructions manual (216 pages) ,
- Manual (101 pages) ,
- Operating instructions manual (156 pages)
Table of Contents
Advertisement
6.3
Establishing the connection to the connectivity module
Start the "SIDRIVE IQ Config" application on your mobile device. The application automatically
activates the Bluetooth interface of your mobile device, and shows active connectivity modules
in a range of approximately 10 m. The BLE name (=Bluetooth name of the device) set in the
factory is "SC400". You can change the name at a later point in time.
Use the "Identify" function to check that you are connected with the required connectivity
module (Page 51).
Note
Length limitations of the BLE name
The BLE name is used to simply identify the device via Bluetooth. The length of the name is
restricted to 7 characters. Do not use any special characters.
SIMOTICS CONNECT 400
Operating Instructions, 05/2020, A5E50161952A AA
6.3 Establishing the connection to the connectivity module
Commissioning
27
Advertisement
Table of Contents
