Quick Commissioning (P0010 = 1) - Siemens SINAMICS G120 List Manual

Hide thumbs Also See for SINAMICS G120:

Table of Contents

2 Parameters

2.6 Quick commissioning (p0010 = 1)

If p0010 = 1 is selected, p0003 (user access level) can be used to select the parameters that

are to be accessed.

At the end of the quick commissioning, set p3900 = 1 to perform the required motor

calculations and reset all other parameters (not included in p0010 = 1) to their default settings.

This only applies for the quick commissioning.

Quick commissioning (p0010 = 1), continued

Open-loop/closed-loop control operating mode

Torque setpoint selection

Motor data identification and rotating measurement 2

Parameter tuning selection

Torque utilization scaling

Completion of quick commissioning

Access level

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

Show Quick Links

Table of Contents