Standard Drive Control - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters
built-in and wall mounting units with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (534 pages)
Table of Contents
Advertisement
Commissioning
5.4 Quick commissioning using the BOP-2 operator panel
Application class
Motors that can be
operated
Commissioning
● Unlike "Dynamic Drive Control," no speed
● Compared with the "EXPERT" setting:
● Standard Drive Control is preset for Power
5.4.3.2
Standard Drive Control
Select the motor standard:
● KW 50HZ: IEC
● HP 60HZ: NEMA
● KW 60HZ: IEC 60 Hz
Set the inverter supply voltage.
Select the motor type. If a 5-digit motor code is stamped on the motor rating plate, select the
corresponding motor type with motor code.
Motors without motor code stamped on the rating plate:
● INDUCT: Third-party induction motor
● 1L... IND: 1LE1, 1LG6, 1LA7, 1LA9 induction motors
Motors with motor code stamped on the rating plate:
● 1LE1 IND 100: 1LE1 . 9
● 1PC1 IND: 1PC1
● 1PH8 IND: Induction motor
● 1FP1: Reluctance motor
Depending on the inverter, the motor list in BOP-2 can deviate from the list shown above.
If you have selected a motor type with motor code, you must now enter the motor code. The
inverter assigns the following motor data corresponding to the motor code.
If you do not know the motor code, then you must set the motor code = 0, and enter motor
data from p0304 and higher from the rating plate.
87 Hz motor operation The BOP-2 only indicates this step if you selected IEC as the motor
standard (EUR/USA, P100 = KW 50HZ).
Rated motor voltage
162
Standard Drive Control
Induction motors
controller needs to be set
–
Simplified commissioning using
predefined motor data
–
Reduced number of parameters
Modules, frame size A ... frame size C
Dynamic Drive Control
Induction, synchronous and reluctance motors
● Fewer parameters compared with the
"EXPERT" setting
● Dynamic Drive Control is preset for Frame
Size D ... Frame Size JX Power Modules
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
- Quick Links:
- Alarms, Faults and System
Hide quick links:
Advertisement
Table of Contents
