Table of Contents
Advertisement
As an example, here is how the lines would look for a node using IP address
192.168.1.200, and subnet mask 255.255.255.0:
set SubnetMask=255 255 255 0
set IPAddress=192 168 1 200
If you later want to reconfigure the recovery diskette to use DHCP to obtain an IP
address instead of static IP addressing, you must reinsert rem in front of the
SubnetMask and IPAddress lines to disable static IP addressing, as follows (based
on the previous example):
REM set SubnetMask=255 255 255 0
REM set IPAddress=192 168 1 200
Specifying multiple 10/100 Ethernet adapters
If the Model 326 has more than one 10/100 Ethernet adapter (per node), then you
must configure the PSM recovery diskette to target the 10/100 Ethernet adapter to
be used for disaster recovery over the network. On the PSM recovery diskette, edit
the file a:\net_sets.bat, and add the following line:
set SLOT=slotvalue
where slotvalue is one of the following, depending on the PCI slot (on the rear of
the node) in which the targeted 10/100 Ethernet adapter is installed:
0x0027
0x0001
0x0022
0x0023
0x0044
0x0045
Restoring the system drive using the PSM recovery diskette
To restore the system drive from a backup image created through the PSM Disaster
Recovery panel as described above, you must use a PSM recovery diskette created
through the Disaster Recovery panel. If you did not create a PSM recovery diskette,
you must use the Recovery CD as described in "Chapter 9. Using the Recovery and
Supplementary CDs" on page 123 to restore the system drive to its original (factory)
configuration.
To restore the system drive:
1. Set the write-protection tab of the PSM recovery diskette to the write-protect
2. Insert the PSM recovery diskette in the diskette drive of the node, and restart
3. The recovery process begins. The PSM recovery diskette software locates the
66
Model 326 User's Reference
Change the IPAddress value to match the IP address you want to assign to the
node, during the recovery operation. Do not insert dots between the numbers
(octets) in either value.
For the integrated Ethernet adapter
For PCI slot 1
For PCI slot 2
For PCI slot 3
For PCI slot 4
For PCI slot 5
position. This prevents accidental initiation of the recovery process (by booting
the node with the PSM recovery diskette in the diskette drive).
the node.
first backup image it can find, based on the backup locations specified when the
diskette was created. When it locates a backup image, it begins restoring the
system drive from the image. During the restore operation, the hard disk drive
LED (on the front right of the node's hard disk drive) will flash green or stay
nearly solid green; this indicates write activity to the system volume.
Note: If the hard-disk drive LED stays off for at least 10 minutes since you
restarted the node, then there is a problem with the recovery procedure
Advertisement
Table of Contents
Troubleshooting
