Preparatory Settings - Sony HXC-100 Operating Instructions Manual
Hd color camera
Hide thumbs
Also See for HXC-100:
- Service manual (206 pages) ,
- Operating instructions manual (149 pages) ,
- Service manual (130 pages)
Advertisement
Preparatory Settings
Adjusting the Black Balance and White
Balance
In order to maintain high picture quality when using the
camera, it is necessary to set the black balance and white
balance appropriately for the conditions.
Note
When a CCU or an external control device, such as an RCP/
RM, is connected, the black balance and white balance are
controlled from the external device or the HKCU-FP1 attached
to the CCU, and adjustment on the camera is disabled.
Black balance adjustment
The black balance needs adjustment in situations like the
following:
• The first time the camera is used
• When the camera is used after a long period of disuse
• When the surrounding temperature changes greatly
• When the gain value is changed using the setup menus
Normally, there is no need to adjust the black balance every
time the camera is turned on.
White balance adjustment
Always adjust the white balance when lighting conditions
change.
To adjust the black balance
Push the AUTO W/B BAL switch to BLK.
S H U T T
E R
O FF
W H T
O N
R E T
S E L
B LK
IN T E R
C O M L
E V E L
AUTO W/B BAL switch
Automatic black balance adjustment begins.
In automatic adjustment of black balance, both the black set
and black balance are adjusted.
During adjustment, the message "ABB: EXECUTING" will be
displayed on the viewfinder screen.
When the adjustment process is completed, the message
"ABB: OK" will be displayed.
The adjusted value is automatically stored in memory.
The black balance values stored in memory will be preserved
even when the camera power is turned off.
Notes
• During black balance adjustment, the iris will be
automatically closed.
• During black balance adjustment, the gain switching circuit
will work automatically, and the viewfinder screen will flicker
several times. This is not a malfunction.
To adjust the white balance
1
Select the built-in filter according to the lighting
conditions with the filter select knob (1: Clear, 2:
1/4 ND, 3: 1/16 ND, 4: 1/64 ND).
Filter select knob
2
Place a white pattern, as shown below, with the same
lighting conditions as the subject, and zoom in on it.
A white object (white cloth, a white wall, etc.) near the
subject may be used in place of a white pattern.
A rectangle centered in the screen:
The length of the sides must be at least 70% of the
height and width of the screen.
Within this rectangle, there must be an area of
white greater than 10% of the entire screen.
Note
Be careful not to have any spots of high illumination in the
rectangle.
3
Adjust the lens iris opening.
With a manually adjusted lens: Set the opening to an
appropriate value.
With a lens which has automatic iris control: Set the
lens' automatic/manual iris control switch to
automatic.
4
Select white balance memory A or B with the WHITE
BAL switch and push the AUTO W/B BAL switch
toward WHT.
S H U T T
E R
O FF
W H T
O N
R E T
S E L
B LK
IN T E R
C O M L
E V E L
AUTO W/B BAL switch
Automatic white balance adjustment begins.
During adjustment, the message "AWB: EXECUTING" will be
displayed on the viewfinder screen.
WHITE BAL switch
15
Preparatory Settings
Advertisement
Chapters
