Table of Contents
Advertisement
8.
Take care to ensure that the memory module cover is firmly closed.
9.
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1.
2.
3.
4.
5.
6.
7.
User's Manual
Seat the memory module cover in place and secure it with the screw.
Figure 3-14 Seating the memory module cover
1. Memory module cover
Install the battery pack - refer to
Chapter 5, Power and Power-Up Modes, if required.
- to confirmed it, Start -> Control Panel -> System and Security ->
System icon.
Shut down the computer - make sure the Power indicator is off (refer
to the
Turning off the power
required).
Remove the AC adaptor and all cables and peripherals connected to
the computer.
Close the display panel.
Turn the computer upside down and remove the battery pack.
Loosen the screw securing the memory module cover in place -
please note that the screw is attached to the cover in order to prevent
it from being lost.
Slide your fingernail or a thin object under the cover and lift it off.
Push the latches away from the module in order to release it - a spring
will force one end of the module up at an angle.
1
2
2. Screw
Replacing the battery pack
section in Chapter 1, Getting Started if
Qosmio F750 Series
section in
3-43
- Quick Links:
- Internal Hardware Components
- System Recovery
Hide quick links:
Advertisement
Table of Contents
