GUARANTEE CONDITIONS INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTIONS INSTALLING THE COOKER HOOD Welcome to the world of Electrolux Thank you for choosing a fi rst class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux...
Refer to your local • If the room where the hood is to be used Electrolux Service Force Centre. Always contains a fuel burning appliance such as insist on genuine spare parts. a central heating boiler then its fl ue must be of the room sealed or balanced fl...
6 electrolux OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Cooker Hood Controls The hood can be switched on pushing directly onto the requested speed without fi rstly having to select 0/1...
Page 7
7 electrolux OPERATING INSTRUCTIONS By a brief pressing the motor is set to the second Touch control lit Second speed on speed. By pressing the touch control for approximately Flashing touch Delay function on 2 seconds the Delay function is enabled, i.e...
Page 8
8 OPERATING INSTRUCTIONS To Operate Select the required fan speed and light if required. Recirculation recirculation mode contaminated air enters the cooker hood through the grease fi lters. The air is cleaned by passing through the charcoal fi lters before being passed back into the kitchen through the grilles in either side of the chimney stack.
9 electrolux MAINTENANCE AND CLEANING MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fi...
Page 10
10 electrolux MAINTENANCE AND CLEANING Cleaning of the Metal Cassette Filters Alarm reset • Stop the motor. • Press the F -touch control for at least 4 seconds until the T1 -touch control fl ashes. Cleaning the fi lters • Filters can be washed in the dish machine.
11 MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. Replacing the Charcoal Filter This fi lter cannot be washed or regenerated, and must be replaced when the F touch control starts to fl ash, or at least once every 4 months.
Page 12
12 electrolux MAINTENANCE AND CLEANING Changing the Halogen Light • Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand. • Remove the halogen lamp from the lamp holder by pulling gently.
13 SOMETHING NOT WORKING SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Solution Symptom • Check the hood is connected to the The cooker hood will not start electricity supply.
14 electrolux GUARANTEE/CUSTOMER SERVICE GUARANTEE/CUSTOMER SERVICE Standard guarantee conditions the United Kingdom. We, Electrolux, undertake that if within • Appliances found to be in use within commercial environment, plus 12 months of the date of the purchase those which are subject to rental this Electrolux appliance or any part agreements.
• The appliance is installed and used accordance with instructions issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes. • The appliance installed accordance...
17 INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS It is dangerous to alter the specifi cations or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT OF CANOPY: 46mm HEIGHT OF CHIMNEY: (UPPER SECTION) 465mm (LOWER SECTION) 740mm WIDTH OF CANOPY :...
18 electrolux ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS THIS APPLIANCE MUST BE EARTHED Electrical Requirements This appliance is fi tted with a 3 core Any permanent electrical installation mains cable and must be permanently must comply with the latest I.E.E. connected to the electricity supply...
19 INSTALLING THE COOKER HOOD INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air.
Page 20
20 electrolux INSTALLING THE COOKER HOOD The cooker hood is made up of the following components: Ref Qty Product Components Hood body, complete with controls, lighting, fan and fi lters. Telescopic Chimney comprising: Upper section Lower section Extensions metal ø150-120 Ducting spigot ø120-125 Ducting fl...
Page 21
21 INSTALLING THE COOKER HOOD Clearance Height When installed between adjoining wall The cooker hood is designed to be cabinets, the wall cabinets must not fi tted over a cooking appliance at the overhang the hob and the distance...
Page 22
22 electrolux INSTALLING THE COOKER HOOD • Mark a reference point as indicated Fitting the Wall Brackets at 116 mm from the vertical reference Wall marking: line and 306 mm above the horizontal • Draw a vertical line on the supporting reference line.
Page 23
23 INSTALLING THE COOKER HOOD Fitting the Hood Body • Before starting to fi x the hood body, tighten the two screws Vr located on the top of the hood body. • Hook the hood body onto the two 4.2x44.4mm screws item 12a.
Page 24
24 electrolux INSTALLING THE COOKER HOOD Recirculation The cooker hood is supplied specifi ed for use in the recirculation mode, with the charcoal fi lter fi tted. In the recirculation mode contaminated air is passed through the charcoal fi lter to be purifi...
Page 25
25 INSTALLING THE COOKER HOOD Extraction The charcoal fi lter is not required in this mode and should be removed. Ducting The ducting used must be Ø150mm (6ins), or Ø125mm (5ins) in diameter. If possible duct through the wall immediately above the hood body.
Page 26
26 electrolux INSTALLING THE COOKER HOOD Electrical Connection and Working Test Before fi tting the chimney to the canopy make the electrical connection as described in the section titled “ELECTRICAL CONNECTION”. When the electrical connection has been made, test the speed fan and worktop illumination.