Dear customer, Please read these operating instructions carefully. Pay particular attention to the section “Safety information” on the first few pages. Please retain these operating instructions for later refer- ence. Pass them on to possible new owners of the appliance. The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety.
Safety Electrical Safety • The appliance may only be connected by a registered specialist. • In the event of any faults or damage to the appliance: remove fuses or switch off. • It is not permissible to clean the appliance with a steam or high pressure cleaner for safety reasons! •...
Page 6
To Avoid Damaging Your Appliance • Do not line your oven with aluminium foil and do not place a baking tray or dish on the oven floor, otherwise the oven enamel will be damaged by the resulting build up of heat. •...
Disposal Disposing of the packaging material All materials used can be fully recycled. Plastics are marked as follows: • >PE< for polyethylene, as used for the outer wrapping and the bags inside. • >PS< for polystyrene foam, e.g., as used for the padding materials. They are completely free of CFCs.
Oven accessories Combination shelf For dishes, cake tins, items for roasting and grilling. Fat tray For roasting or for collecting fat. Baking tray For cakes and biscuits...
Before Using for the First Time Setting the Time The oven will only operate when the time has been set. 1. The time function indicator D will flash after the appliance has been connected to the mains or following a power failure. 2.
Initial Cleaning Before using the oven for the first time you should clean it thoroughly. Caution: Do not use any caustic, abrasive cleaners! The surface could be damaged. To clean metal fronts use commercially available cleaning agents. 1. Turn the oven function switch to oven lighting L. 2.
Using the Rings Also refer to the operating instructions for your built-in hob. It con- tains important information on ovenware, operation, cleaning and care. Heat settings • You may select the heat settings within the range of settings 1-9. • Intermediate positions may be selected between settings 2 and 7. They are marked with a dot.
Cooking with the Rings 1. For heating up/browning, select a high heat setting. 2. As soon as steam starts to form or the oil is hot, turn back to the heat setting necessary for further cooking. 3. To stop cooking, turn back to the zero position.
Using the Oven Switching the Oven On and Off 1. Turn the oven “functions switch” to the required function. 2. Turn the “temperature selection” switch to the required temperature. The yellow oven power indicator is illuminated while the oven is in use. The red temperature pilot light comes on while the oven is heating up.
Oven Functions The oven has the following functions: Oven lighting With this function you can illuminate the oven interior, e.g., for clean- ing. The heating element is not in use. S Pizza & baking For baking cakes on one level and for pastries that need more brown- ing and a crispy base.
Z Dual grill For grilling larger quantities of flat foods such as steaks, escalopes or fish, or for toasting. Top heat and the grill heating element are in use. F Grill For grilling flat foods placed on the middle of the shelf such as steaks, escalopes or fish, or for toasting.
Inserting the Shelf and Universal Baking Tray Anti-tip device All slide-in units have a small bulge on the left and right. This bulge is an anti-tip device and must always point to the rear of the oven. Tray or universal baking tray: The anti-tip device must point to- wards the rear of the oven.
Inserting/Removing the Fat Filter The fat filter protects the rear wall heating element against splashes of fat when roasting. Inserting the fat filter Holding the fat filter by the tab, in- sert the two retainers into the opening on the rear wall of the oven (fan opening) from the top downwards.
Working with the Electronic Clock The electronic clock has the following functions: Countdown ] To set a countdown. A signal sounds after the time has elapsed. This function does not affect the functioning of the oven. Cook time < To set how long the oven is to be in use. End time >...
General information • Once a function has been selected the corresponding function indi- cator will flash for approx. 5 seconds. During this time the required times can be set using the + or - button. • After the required time has been set the function indicator will flash again for approx.
Page 22
Countdown ] 1. Press selection button Y repeatedly until the countdown function indicator ] flashes. 2. Using the + or - button set the required countdown ]. (Max. 2 hours and 30 minutes.) After approx. 5 seconds the display will show the remaining time. The countdown function indicator ] is illuminated.
Page 23
Cook time < 1. Press selection button Y repeatedly until the cook time function indicator < flashes. 2. Using buttons + or - set the re- quired cooking time. After approx. 5 seconds the display will revert to the time. The cook time function indicator <...
Page 24
End time > 1. Press selection button Y repeatedly until the end time func- tion indicator > flashes. 2. Using buttons + or - set the time at which you want the oven to switch off. After approx. 5 seconds the display will revert to the time.
Page 25
Cook time < and End time > combined Cook time < and end time > can be used together if the oven is to switch on and off automatically at a later time. 1. Using the cook time < function sets the time required for the dish to cook.
Page 26
Changing TIME The time can only be changed if neither of the automatic functions (cook time < or end time >) has been set. 1. Press selection button Y repeatedly until the TIME function indicator flashes. 2. Using buttons + or - set the cur- rent time.
Mechanical Door Lock When the appliance is delivered, the door lock is deactivated. Activate the door lock Pull the safety catch forwards until it locks in place. Open the oven door: 1. Shut the door. 2. Press the safety catch and keep it depressed.
Uses, Tables and Tips Boiling The information given in the following tables is for guidance. The switch setting required for cooking depends on the quality of the pans and the type and quantity of food. Settings for cooking on the rings Cooking / Switch Continuation...
Baking Use the pizza & baking S, fan cooking U or conventional O oven functions for baking. Remove the fat filter when baking, as otherwise the baking time is longer and the surface will brown unevenly. Baking tins • Coated baking tins and tins made of dark metal are suitable for conventional O heat.
Page 30
General information • Always count the shelf positions from the bottom upwards. • Insert baking trays with the sloped edge to the front! • Always place cake tins in the middle of the shelf. • With pizza & baking S or conventional O you can also bake two items simultaneously by placing the tins next to one another on the shelf.
Baking Table Baking on one shelf position Pizza & baking S Conventional O Type of cake or pastry Time Shelf Tempera- Shelf po- Tempera- For both position ture sition ture functions from ºC from ºC Hrs.: Mins. bottom bottom Cakes in cake tins Ring-shaped or 150-160 160-180...
Page 32
Pizza & baking S Conventional O Type of cake or pastry Time Shelf Tempera- Shelf po- Tempera- For both position ture sition ture functions from ºC from ºC Hrs.: Mins. bottom bottom Fruit flan (with a yeast 150-170 170-190 0:25-0:50 dough/sponge base) Fruit flans on shortcrust 160-170...
Page 33
Baking on several shelf positions Fan cooking U Time Type of cake or pastry Hours: Shelf position from bottom Tempera- Mins. ture ºC 2 Levels 3 Levels Cakes and pastries on baking sheets Cream puffs/eclairs 0:35-0:60 160-180 Dry streusel cake 140-160 0:30-0:60 Biscuits...
Tips for baking Baking result Possible cause Solution Insert the cake at a lower The cake is under- Wrong shelf position shelf position cooked at the bottom Cooking temperature too high Set to a lower temperature The cake collapses (is sticky, soft in the middle, damp patches)
Pies and Gratin Table Conventional O Rotitherm I Time Shelf Shelf Temp. Temp. Hrs: Mins. position position °C °C from from bottom bottom Pasta bake 180-200 160-170 0:45-1:00 Lasagne 180-200 160-170 0:25-0:40 Vegetables au 200-220 160-170 0:15-0:30 gratin Pizza ba- 200-220 160-170 0:15-0:30...
Frozen Ready Meals Table Food to be Shelf Temperature Time cooked position Oven function from bottom in accordance in accordance Conventional with the Frozen pizza with the maker's maker's instruc- instructions tions Chips Rotitherm I 200-220 °C 15-25 Mins. (300-600 g) in accordance in accordance Conventional...
Roasting Use the rotitherm I or conventional O oven functions for roasting. Ovenware for roasting • Any heat-resistant dish is suitable for roasting (refer to the manufac- turer's instructions!). • If the dish has plastic handles, check that they are heat-resistant (re- fer to manufacturer's instructions!).
Page 38
Notes on the roasting table Information is given in the table on suitable oven functions, tempera- ture settings, cooking times and shelf positions for various types of meat. The information is for guidance. • We recommend roasting meat and fish with a minimum weight of 1kg in the oven.
Roasting table Conventional O Rotitherm I Type of meat Quantity Time Weight Shelf po- Tempera- Shelf Tempera- Hours:Mi sition ture position ture from bot- ºC from ºC bottom Beef Pot roast 1-1.5 kg 200-250 2:00-2:30 Roast beef or fil- per cm of thickness per cm of - rare...
Page 40
Conventional O Rotitherm I Type of meat Quantity Time Weight Shelf po- Tempera- Shelf Tempera- Hours:Mi sition ture position ture from bot- ºC from ºC bottom Game Saddle of hare, up to 1 160-170 0:25-0:40 220-250 haunch of hare Saddle of venison 1.5-2 kg 210-220 160-180...
Grilling To grill use the grill F oven function or dual grill Z with temperature setting z. Important: Always grill with the oven door closed. Always pre-heat the empty oven for 5 minutes using the grill func- tions! Ovenware for grilling •...
Defrosting To defrost, use the defrost oven function without setting a tempera- ture. Dishes for defrosting • Remove packaging and place the food on a plate on the shelf. • Do not use a plate or dish to cover as these significantly increase the defrosting time.
Preserving For making preserves, use the bottom heat Ü oven function. Preserving jars • When making preserves, use only commercially available jars of the same size. Jars with twist-off tops or with a bayonet fastening and metal containers are not suitable. Shelf positions •...
Preserving Table The stated times and temperatures are for guidance only. Temperature Preserving Continued in switched time until cooking off oven Preserves bubbles form at 100°C standing time °C Mins. Mins. Soft fruit Strawberries, blue- berries, raspberries, 160-170 35-45 ripe gooseberries Unripe gooseberries 160-170 35-45...
Cleaning and Care Warning: For safety reasons cleaning the appliance with a steam jet cleaner or high-pressure water cleaner is not permissible! Exterior of the Appliance Wipe the front of the appliance with a soft cloth dipped in warm soapy water.
Cleaning with Pyroluxe Warning! The oven becomes very hot during this procedure. Children must be kept well away. Important: All slide-in parts must be removed from the oven before cleaning with pyroluxe. If you use the oven shelf runners obtainable as special accessories, they must be removed before cleaning with pyroluxe.
Shelf Support Rails The shelf support rails on the left and right hand sides of the oven can be removed for cleaning the side walls. Removing the shelf support rails 1. Remove the screw. 2. Pull the rail away from the oven wall at the back and swivel towards the front (1).
Page 48
Fitting the shelf support rails Take care when fitting the rails that the rounded ends of the guide rails are pointing forwards! 1. To re-insert, first hook the rail into place at the front (1). 2. Swivel the rail towards the rear and push into place (2).
Oven Lighting Warning: There is a danger of electric shock! Prior to changing the oven light bulb: – Switch off the oven! – Remove the fuses in the fuse box or switch off the circuit breaker. Place a cloth on the oven floor to protect the oven light and glass cover.
Oven Door The oven door of your appliance may be removed for cleaning. Removing the oven door 1. Open the oven door completely. 2. Completely fold back the brass- coloured clamping lever on both door hinges. 3. Grip the oven door with both hands on the sides and close it to about 3/4 going past the point of resist- ance.
Oven door glass The oven door is fitted with four sheets of glass set next to one an- other. The inner sheets can be removed for cleaning. Caution: The following steps are to be performed only when the oven door has been removed. If the glass is removed while the door is at- tached, the leighter weight may cause it to spring up and cause injury.
Page 52
Replacing the centre glass plates 1. From above, insert the centre plates obliquely into the retaining frame at the handle, one after another. 2. Lower the centre plates down and push them towards the lower edge of the door as far under the retain- ing frame as they will go.
What to do if ... Symptom Possible cause Remedy The appropriate cooking The cooking zones do zone has not been switched Switch on the cooking zone. not work. The circuit breaker (at the household fuse box) has Check the circuit breaker or tripped or the fuse has fuse.
Page 54
Warning: Repairs to the applicance may only be carried out by ap- proved service engineers! Repairs carried out by inexperienced persons may cause serious injury to the user. If the appliance has been used improperly, the customer service engi- neer’s visit or that of the specialist dealer will not be free of charge, even during the warranty period.
Technical Data Oven Interior Dimensions Height x Width x Depth 31 cm x 41 cm x 41 cm Capacity (usable capacity) 52 l Regulations, Standards, Directives This appliance meets the following standards: • EN 60 335-1 and EN 60 335-2-6 relating to the safety of electric appliances for household use and similar purposes and •...
Service The section "What do I do if...“ lists some faults that you can remedy yourself. Look there first if a fault occurs. Is it a technical fault? Then contact your nearest customer service centre. (Addresses and tele- phone numbers can be found under "Customer Service Centres“.) Always prepare in advance for the discussion.