Basic Connections; An Antenna); Connecting Directly To Cable; Cable Box Connections - Sony KLV-23HR1 Operating Instructions Manual
Lcd color tv
Hide thumbs
Also See for KLV-23HR1:
- Service manual (73 pages) ,
- Operating instructions manual (56 pages) ,
- Dimensions (1 page)
Table of Contents
Advertisement
Basic Connections
(Connecting Cable TV or
an Antenna)
When connecting
an antenna or cables, remove the
rear cover of the TV beforehand.
Removing the rear cover
1
Slide the rear cover upward by approx.
1 cm
(13/32
inch) while holding
it with both hands as
shown in the diagram below.
2
Pull the rear cover towards
you.
Attaching
the rear cover
1
Hold the rear cover with both hands, then fit the
four detents on the rear cover into the
corresponding
keyholes
on the TV while keeping
the rear cover approx.
1 cm (_3/32inch) higher
than the TV as shown in the diagram
below.
2
Slide the rear cover downward
while keeping it
pressed against the TV. If the rear cover fails to
fit in the lower keyholes,
push it simultaneously
at the positions
marked A in the illustration
below.
hr_s_a_i
hg and Cow_w_ec_ing
_heIV
Connecting
directly to cable or an
antenna
VHF only or VHF/UHF
or cable
75-ohm coaxial
Rear of TV
cable (supplied)
_'_
VHF/UHF
Note
It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration, if you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.
Cable box connections
Use this hookup if:
• You subscribe
to a cable TV system that uses
scrambled
or encoded
signals requiring
a cable
box to view all channels,
and
• You do not intend to hook up any other audio or
video equipment
to your TV.
1
Connect
the coaxial connector
from your cable
service to the cable box's IN jack.
2
Using the supplied
75-ohm coaxial cable,
connect the cable box's OUT jack to the TV's
VHF/UHF
jack.
75-ohm coaxial
Cable
cable (supplied)
_;_LE_
,_
Rear of TV
,1
IN
_
OUT
Cable box
Also, set "Cable"
to "On" in the _
(Channel)
menu (See page 20).
Tips
• Your Sony remote
control
can be programmed
to operate
your
cable box (See "Programming
the remote
control"
on page
31).
• To change channels using the cable box, set your TV to
channel 3 or 4 depending on the cable box channel output.
• if you will be controlling
all channel
selection
through
your
cable box, consider
using the Channel
Fix feature to set your
TV to channel
3 or 4 (See page 21).
9
Advertisement
Table of Contents
