Troubleshooting; Sewing - Brother S-7200C Instruction Manual
Single needle direct drive straight lock stitcher with thread trimmer
Hide thumbs
Also See for S-7200C:
- Manual de instrucciones (80 pages) ,
- Manual (76 pages) ,
- Brochure (6 pages)
Table of Contents
Advertisement
14. TROUBLESHOOTING
14. TROUBLESHOOTING
Please check the following points before calling for repairs or service.
If the following remedies do not fix the problem, turn off the power switch and consult a qualified technician or the place of
purchase.
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the cover of the control box. Touching areas where high voltages are present can result in severe
injury.
Turn off the power switch and disconnect the power cord before carrying out troubleshooting.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
14-1. Sewing
Items with a "*" in the "Page" column should only be checked by a qualified technician.
Problem
1
Upper thread is not tight.
2
Lower thread is not tight.
3
Loops appear in seam.
4
Skipped
stitches
while sewing
63
Is the upper thread tension too weak, or is the lower thread tension
too strong?
Adjust the upper thread tension or lower thread tension.
Is the needle and feed timing correct?
Advance the needle timing.
0573M
Is the lower thread tension too weak, or is the upper thread tension
too strong?
Adjust the lower thread tension or upper thread tension.
0574M
Is the thread path not smooth enough?
Use a file with a fine grain or sandpaper to polish smooth the
thread path.
Is the bobbin not turning smoothly?
Pull out the lower thread to check that there is no slackness in
the thread tension, or replace the bobbin or bobbin case.
0977M
occur
Is the needle tip bent? Is the needle tip blunt?
If the needle tip is bent or broken, replace the needle.
Is the needle properly installed?
If it is incorrect, install the needle correctly.
Is the machine properly threaded?
If it is incorrect, thread the thread correctly.
Is the presser foot pressure too weak?
Adjust the presser foot pressure.
Is the needle too thin?
Replace the needle with a needle that is one rank thicker.
Is the presser foot too high?
Adjust the height of the presser foot.
Is the thread take-up spring too weak?
Adjust the tension of the thread take-up spring.
Is the needle and rotary hook timing correct?
Adjust the height of the needle bar.
Adjust the clearance between the needle and the tip of the
rotary hook.
0470M
DANGER
CAUTION
Possible cause
S-7200C
Page
43
60*
43
15
17
44
57*
56*
60*
61*
- Quick Links:
- Error Code Displays
Hide quick links:
Advertisement
Table of Contents
