Adjusting Of The Feed Dog Height - Brother S-7200C Instruction Manual
Single needle direct drive straight lock stitcher with thread trimmer
Hide thumbs
Also See for S-7200C:
- Manual de instrucciones (80 pages) ,
- Manual (76 pages) ,
- Brochure (6 pages)
Table of Contents
Advertisement
13-6. Adjusting of the feed dog height
Becomes
higher
Becomes
lower
Becomes higher
Standard
Becomes lower
Becomes higher
Standard
Becomes lower
The standard height of the feed dog (1) when it is at its
maximum height above the top of the needle plate is 0.8 mm
<-[][]S / [][]3>
for -[][]S / [][]3 specifications, and 1.2 mm for -[][]5 specifica-
tions.
0.8mm
<-[][]5>
1.2mm
2279M
1. Turn the pulley until the feed dog (1) rises to the highest
2. Tilt back the machine head.
3. Loosen the screw (2).
4. Turn the feed lifting rock bracket stud (3) within a range of
5. Tighten the screw (2).
* If you are worried about the angle of the feed dog (1), turn
4254M
Needle plate
2281M
Becomes higher
Standard
Becomes lower
2282M
S-7200C
position.
90° from the reference line (4) to adjust the vertical height
of the feed bar (5). (Fig. [A])
the shaft (6) while carrying out the above adjustment. (Fig.
[B])
(Refer to "13-7. Adjusting the feed dog angle" on the next
page for details of this operation.)
13. STANDARD ADJUSTMENTS
58
- Quick Links:
- Error Code Displays
Hide quick links:
Advertisement
Table of Contents
