Table of Contents
Advertisement
TV output signal
Problem
Display on TV is poor
No display
If you turn the computer off in Standby mode while the display is on TV, the
computer will select either the internal LCD or an external computer CRT
as the display device.
Standby/Hibernation
Problem
The system will not
enter Standby/
Hibernation
Real Time Clock
Problem
The following message
is Displayed on the
LCD:
RTC battery is low or
CMOS checksum is
inconsistent. Press [F2]
key to set Date/Time.
User's Manual
Procedure
Make sure the TV type is correct for your area:
NTSC (US) or PAL (Europe).
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
If problems persist, contact your dealer.
Procedure
Is Windows
®
Media Player open? The system
might not enter Standby/Hibernation, if
®
Windows
Media Player is either playing a
selection or finished playing a selection. Close
®
Windows
Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Procedure
The battery for RTC is wearing. Set the date and
time in BIOS setup with the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].
Troubleshooting
The
Keyboard.
9-13
Advertisement
Table of Contents
