Removing An I/O Module - IBM 8852 - BladeCenter H Rack-mountable Service Manual
Problem determination and service guide
Hide thumbs
Also See for 8852 - BladeCenter H Rack-mountable:
- Installation and user manual (82 pages)
Table of Contents
Advertisement
Removing an I/O module
To remove an I/O module or module filler, complete the following steps.
Note: These instructions assume that the BladeCenter unit is connected to power.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Disconnect all cables from the module.
3. Pull the release handle or handles to the open position. The module moves out
4. Slide the module out of the bay. Within 1 minute, install either another module
5. If you are instructed to return the I/O module, follow all packaging
44
BladeCenter H Type 8852, 7989, and 1886: Problem Determination and Service Guide
I/O
module
Release handle
(open)
on page 29.
of the bay approximately 0.6 cm (0.25 inch).
Note: The modules and fillers in I/O bays 1 through 6 each have one release
handle; the modules and fillers in I/O bays 7 through 10 each have two release
handles.
or a filler into the module bay.
instructions, and use any packaging materials for shipping that are supplied to
you.
Single
module
filler
Module
filler
Double
module
filler
I/O module
Release handles
(open)
Hide quick links:
Advertisement
Table of Contents
