Table of Contents
Advertisement
After several OFIR cycles, put imaging oil in the regular tank, circulate it and check if it is clean. If the
imaging oil is not clean, perform another OFIR, and clean manually the below components:
●
Ink tank (especially the sensors area – the space between the optical lenses)
●
BID-FI
●
Hoses leading from the ink tank to the BID
For more information, refer to
Building HP Indigo ElectroInk Silver
Follow these steps for building HP Indigo ElectroInk Silver.
Basic definitions and assumptions for working with HP Indigo ElectroInk Silver:
●
Silver-dedicated ink stations and BIDs — Use the ink stations and BIDs 1, 6 or 7 for HP Indigo
ElectroInk Silver.
●
DFE — Make sure that the DFE is version 5.2_IR7.2 + HF18.2 + HF23.0, to support the HP Indigo
ElectroInk Silver. Also, prior to sending a job to print, verify that the HP Indigo ElectroInk Silver is
defined properly in the job.
1.
Install the Silver-dedicated BID base and developer roller (see
developer roller on page 7
2.
In the press software, go to Main Menu > Ink and BID > Ink Management > Ink List.
3.
From the list that opens, select the Silver ink and touch Import.
Import screen, select the ink file US-Silver-EI.usi and touch Import.
4.
In the
5.
Run the
proceed to next step in the wizard).
a.
In the
●
●
b.
In the
On-press Fast Ink Replacement (CA394-00760).
Build Ink wizard from Main Menu > Ink and BID > Ink Replacement > Build Ink. (Touch Next to
Method tab, select:
Build ink for a new color – To build the ink and also re-calibrate the ink density sensor in the
ink tank.
Calibration can – To use this color calibration cartridge to create an ink solution at an
exact density solution.
Scan New Ink tab, scan the calibration cartridge barcode.
Installing the dedicated BID base and
Building HP Indigo ElectroInk Silver
9
Advertisement
Table of Contents
