Table of Contents
Advertisement
x. UHF Channel 41
4
.
C2
VE 6)
Tuning Indicator and Band Indicator Lamps
ig
The red famp when fIt shows you are In the Band
including channels 2 through 6, the yellow lamp
when lft shows you are in the band Including
channels 7 through 13, and the green lamp when
lit shows you are in the band Including chan-
nels 14 through 83. Within each of these bands,
stabilize.
again.
above) as guides.
preset.
now set to ON.
After the presetting has been completed, replace the Channel In-
dicating Segments to correspond to yéur presetting (see page 13)
and close the front panel.
@ If there Is a VTR position to be included, refer to page 13.
@ To use your projection system with a cable-television system,
contact a representative of the cable company for Instructions
regarding channel selection. In most cases, this adjustment will
be made by the cable company at the time of installation.
Press 'the TUNING-up
> of -down
<
Button. (Do not hold the button
in, just press It momentartly). Allow 1 or 2 seconds for the picture to
the multi-segment Tuning Indicator will show In
what portion of the band you are tuned to atany
:
given moment,
with the left-most segment
in-
dicating the lowest frequency within each bana,
and
the
right-most
segment
indicating
the
highest frequency within each band.
:
@ In strong signal areas, tuning may sometimes stop between channels.
'If a station Is not recelved, press the TUNING-up
p> or-down
<q Button
Repeat step CG] as required until your desired station appears on the
screen. Use the Tuning indicator and Band Indicator Lamps (explained
Repeat steps 8, 44) and 5) for all the channel positions you wish to
Set the CHANNEL SET Switch to OFF and make sure the AFT Switch is
11
Advertisement
Table of Contents
