Table of Contents
Advertisement
Figure 10. Inserting the enclosure
4. Secure the enclosure with screws in the rack mounting screw holes on each side of the enclosure.
See Figure 11 on page 15.
Figure 11. Securing the front of the enclosure
5. Reinstall the left and right end caps.
The left end cap has indicator windows that align with the status LEDs (light-emitting diodes) on the
edge of the enclosure.
a) Ensure that the serial number on the left end cap matches the serial number on the left flange
("ear") on the front of the enclosure.
b) Fit the slot on the top of the end cap over the tab on the flange.
c) Rotate the end cap down until it snaps into place.
d) Ensure that the inside surface of the end cap is flush with the flange.
Unpacking an optional 5U expansion enclosure
Before you unpack an optional 5U expansion enclosure, ensure that you review and follow all related
instructions and safety notices.
Before you begin
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially trained persons, a
lifting device, or both to safely lift this part or unit. (C011)
CAUTION: To avoid personal injury, before you lift this unit, remove all appropriate subassemblies
per instructions to reduce the system weight. (C012)
Chapter 2. Installing the system hardware 15
Advertisement
Table of Contents
