Table of Contents
Advertisement
5. Ensure that the drive handle (
(unlocked) position.
6. Align the drive carrier into the appropriate drive slot.
Figure 37. Replace the drive
7. Gently push the drive down until it stops and the bottom of the latch is aligned with the top of the
partition. Ensure that the handle is not open more than 45 degrees from the drive carrier. (
Figure 37 on page 37).
8. Rotate the handle down to lock the drive assembly into the chassis (
9. Ensure the toe on the bottom of the latch is fully engaged with the partition in the chassis.
10. Ensure that the top toe of the latch is also fully engaged (
11. Repeat steps "4" on page 36 through "10" on page 37 for each drive you are replacing.
12. Replace the cover, as described in "Installing or replacing the top cover" on page 37.
13. Slide the expansion enclosure back into the rack, as described in "Installing a 5U expansion
enclosure in a rack" on page 38.
Installing or replacing the top cover
You can replace the top cover on a 5U expansion enclosure during the installation process or after you
complete a service task.
Before you begin
Important: You can install the cover while the expansion enclosure is powered on. To maintain operating
temperature, replace the cover within 15 minutes of completing other service tasks. When the cover is
removed, the reduction in airflow through the enclosure might cause the enclosure or its components to
shut down to protect from overheating.
1
in Figure 37 on page 37) of the drive assembly is in the open
3
in Figure 37 on page 37).
4
in Figure 37 on page 37).
Chapter 2. Installing the system hardware 37
2
in
Advertisement
Table of Contents
