Unplugging Or Plugging In A 10Base-T Cable - IBM 3745 Connection And Integration Manual
Communication controller, nways multiprotocol controller
Hide thumbs
Also See for 3745:
- Hardware maintenance reference (712 pages) ,
- Maintenance information reference (595 pages) ,
- Problem determination manual (387 pages)
Table of Contents
Advertisement
Step
Step
Unplugging or Plugging In a 10BASE-T Cable
Step
Step
6. To check that the cable is locked in place, move the cable
connector from side-to-side while trying to pull it out of the
3746-900 AUI connector. Do not jerk on the cable.
5
Activating the lines
Ask the network operator to activate any lines plugged in.
Note: The line number is the address of the TIC3 that connects the
Ethernet attachment feature.
6
You have finished this procedure
Close and lock the door using the special door key.
1
Starting
Before beginning, you must first do the procedure "Starting Connection
Tasks" on page 3-2
The 10BASE-T connector is next to the AUI connector on the Ethernet
Bridge.
10BASE-T Connection
If you are only plugging in a 10BASE-T cable, go to Step 3 on
page 3-12.
Otherwise, continue with the next step.
2
Unplugging a 10BASE-T cable.
Ask the network operator to deactivate the affected line.
1. Unlock the latch by pressing it.
2. Pull out the plug.
Chapter 3. 3746-900: Installing LCBs and ARCs, Connecting Cables
AUI
Connection
3-11
Advertisement
Table of Contents
