The Arc Assembly B And Its Different Types Of Connector - IBM 3745 Connection And Integration Manual
Communication controller, nways multiprotocol controller
Hide thumbs
Also See for 3745:
- Hardware maintenance reference (712 pages) ,
- Maintenance information reference (595 pages) ,
- Problem determination manual (387 pages)
Table of Contents
Advertisement
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3-34
3745 All Models & 3746-900: CIG
V.24
Figure 3-29. The ARC Assembly B and Its Different Types of Connector
Select the ARC cable that has a label that corresponds to the line
needs:
ITU-T interface type
Destination (DTE or DCE)
Length.
Step 34
Label the new ARC cable
a. Verify that the following information about each ARC from the
plugging sheets is on a pair of ARC cable labels (part number
63F2505):
LCB:
– Number
– Location
IBM 3746-900 name
Range of the LIC 11 addresses.
Connector slot position (+0 to +14 or +16 to +30)
Symbolic line name.
b. Stick these labels at each end of the ARC cable (see 5 in
Figure 3-10 on page 3-15). Be sure to remove any old labels first.
Step 35
Connect the ARC cable to the DTE or DCE
If you are using an ARC V.24, V.35, or X.21, plug its cable interface
connector into the DTE or DCE connector and tighten the retaining
screws.
Note: If you are making a V.35 connection to a French modem or
terminal, refer to the third and fourth bullets of this step.
If you are using an ARC cable that has 3745 connector, plug it into
the connector of the 3745-type cable:
ARC Assembly B
V.35
X.21
IBM 3745
Advertisement
Table of Contents
