IBM System Storage TS3310 Setup And Operator Manual page 245
Tape library
Hide thumbs
Also See for System Storage TS3310:
- Maintenance information (531 pages) ,
- Setup and operator manual (345 pages) ,
- Update manual (37 pages)
Table of Contents
Advertisement
Table C-1. Library Sense Data and associated ASC/ASCQs (continued)
Sense
Key
ASC
ASCQ
6
2Ah
01h
6
2Ah
03h
6
2Ah
04h
6
2Ah
05h
5
2Ch
00h
5
*30h
*00h
5
39h
00h
4-5
3Bh
0Dh
4-5
3Bh
0Eh
Description
Mode parameters have been changed.
Reservations preempted.
Reservations released.
Registrations preempted.
Command sequence error
Incompatible medium installed
Saving pararmeters not supported
The destination element is full.
The source element is empty.
Required Action
**The Mode parameters for the drive have
been changed by an initiator other than the
one issuing the command. Mode Select
parameters were changed by another host,
or commands were cleared by another host.
Failure Isolation Procedure
No action is necessary. These are only
status messages.
Command sequence error.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
Incompatible Media. A Write operation was
requested on a cartridge which is not
writable.
Failure Isolation Procedure
No action is necessary. This is only a
status message.
Saving Parameters is not supported.
Failure Isolation Procedure
No action is necessary. These messages
indicate that a host application sent an
invalid/unsupported command or multiple
hosts attempted to use a drive at the same
time.
The host is attempting to move a cartridge,
but the attempt was rejected as invalid.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
The host is attempting to move a cartridge,
but the attempt was rejected as invalid.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
Appendix C. Sense Data
C-5
Advertisement
Chapters
Table of Contents
