Table of Contents
Advertisement
Error symptoms
Beep/Symptom
5-1 (Sideplane 5V D2D)
5-2 (Sideplane 5V D2D)
6 (Sideplane 3.3V
processor D2D)
7-1 (Sideplane 3.3V I/O
D2D)
7-2 (Sideplane 3.3V I/O
D2D)
8-1 (Processor board D2D) 1.
8-2 (Processor board D2D) 1.
1-5-5-2 (Fan fuse)
Error Symptom
System does not power
up once back together
(loose connection(s)
and/or bent pins)
System powers on but
then turns back off often
with fault light (bent
pin(s); short on board)
System powers up but
does not POST (loose
connection(s); incorrect
processor stepping;
system speed too high for
processors; memory not
stuffed in documented
order; unsupported or
unvalidated DIMMS)
System does not
recognize all installed
processors (loose
connection; bent pin(s) on
processor(s))
1.
Reseat 5V D2D-A (#1) on sideplane board
2.
5V D2D-A on sideplane board
1.
Reseat 5V D2D-B (#2) on sideplane board
2.
5V D2D-B on sideplane board
1.
Reseat 3.3V processor D2D on sideplane board (bottom
left)
2.
3.3V processor D2D on sideplane board (bottom left)
1.
Reseat 3.3V I/O D2D-A on sideplane board (bottom right)
2.
3.3V I/O D2D-A on sideplane board (bottom right)
1.
Reseat 3.3V I/O D2D-B on sideplane board (top right)
2.
3.3V I/O D2D-B on sideplane board (top right)
Reseat processor baseboard
2.
Processor baseboard
Reseat processor baseboard
2.
Processor baseboard
1.
Check T-docking board connections
2.
T-docking board
1.
Reseat boards and D2Ds
2.
Check front panel cable connections
1.
Reseat processor
2.
Processor
1.
Check that screw or other conductive item has not been
dropped into system
2.
Reseat boards and D2D
3.
Check for bent pins on cables
4.
Check for bent pins on processors
1.
Reseat processors and power pods
2.
Check for bent pins on processors
3.
Check cable connections from processor board to power pod
FRU/Action
FRU/Action
Symptom-to-FRU index
229
Advertisement
Table of Contents
