Pci Express; Removing Pci Or Pci Express Cards - HP xw8400 Service And Technical Reference Manual
Hp xw8400: reference guide
Hide thumbs
Also See for xw8400:
- User manual (216 pages) ,
- Technical reference manual (200 pages) ,
- Specification (82 pages)
Table of Contents
Advertisement
PCI Express
PCI Express is a point-to-point architecture and uses a serial data transmission protocol. A single PCI
Express lane consists of four wires and can transmit 250 MB/s in a single direction or 500 MB/s in both
directions simultaneously. This bandwidth is not affected by what is happening on other PCI Express
buses or legacy PCI/PCI-X buses (provided that total bandwidth can be handled by the CPU and the
memory subsystem.) The transmission protocol is somewhat similar to that used for a LAN connection
and contains error correction and detection, packet addressing, and other network features.
PCI Express improves system attributes. PCI Express enables a low-power, scalable, high-bandwidth
communication path with a small number of connections (wires) compared to traditional parallel
interfaces (for example, PCI).
The PCI Express I/O slots can support other PCI Express cards with lesser bus bandwidth than what is
physically defined for the slot. Use the following table to determine compatibility.
For example, a PCI Express x8 card does not work in a PCI Express x1 slot, but a PCI Express x1 card
works in a PCI Express x8 slot.
NOTE
bandwidth. If a PCI Express x8 card is plugged into the PCI Express x8 slot, the card runs at x4
bandwidth.
Slot 4: The HP xw8400 Workstation contains one PCI Express x16 slot that supports x4
bandwidth. If a PCI Express x8 or x16 card is plugged into the PCI Express x8 slot, the card runs
at x4 bandwidth.
Table 4-6
PCI Express compatibility matrix for xw8400
PCI Express x1
Card
PCI Express x4
Card
PCI Express x8
Card
PCI Express x16
Card
Removing PCI or PCI Express cards
1.
Disconnect power from the system (
access panel
facing up. Remove the PCI retainer
2.
Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp
(1) and rotating the clamp toward the back of the system.
72
Chapter 4 Removal and replacement procedures
Slot 3: The HP xw8400 Workstation contains one PCI Express x8 slot that supports x4
Slot 2
x16 mechanical
x16 electrical
Yes
Yes
Yes
Yes
(Access panel on page
Slot 3
x8 mechanical
x4 electrical
Yes
Yes
Yes
No
Pre-disassembly procedures on page
58). Place the workstation on its side with the system board
(PCI retainer on page
69) if present.
Slot 4
x16 mechanical
x4 electrical
Yes
Yes
Yes
Yes
53), and remove the
ENWW
- Quick Links:
- System Board Components
- Memory
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
