Pci Retention Clamp - HP xw8400 Service And Technical Reference Manual
Hp xw8400: reference guide
Hide thumbs
Also See for xw8400:
- User manual (216 pages) ,
- Technical reference manual (200 pages) ,
- Specification (82 pages)
Table of Contents
Advertisement
2.
For short or tall PCI cards, attach the hooks of the PCI retainer (1) under the slots on the rear of
the chassis, and then rotate the retainer down until the retainer arm (2) supports the card.
Figure 4-19
PCI retention clamp
1.
Disconnect power from the system (
access panel
facing up.
2.
Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp
and rotating the clamp toward the back of the system.
Figure 4-20
ENWW
Installing the short or tall card PCI retainer
(Access panel on page
Opening the PCI retention clamp
Pre-disassembly procedures on page
58). Place the workstation on its side with the system board
Removing and replacing components
53), and remove the
71
- Quick Links:
- System Board Components
- Memory
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
