Table of Contents
Advertisement
The factory default is set to DHCP for the projector. You can see the current IP
address in the Information menu.
You can change the settings in the Network Setting menu. To access the Network
Setting menu, follow the steps below:
1. Press the Menu button to open the main menu.
2. Press the cursor left/right button to move to the Information menu.
3. Press the cursor up/down button to move to Network Setting in the
Information menu.
4. Press the Enter button to access the Network Setting menu. The Netowrk
Setting menu is shown below.
Using the DHCP address settings
Set the IP Setting to DHCP if you are using a DHCP server that will assign an IP
address to the projector.
Chapter 6. Remote network operation
6-5
Advertisement
Table of Contents
