Installation; Fitting The Iop - Siemens SINAMICS Series Operating Instructions Manual
Intelligent operator panel. intelligent commissioning and application configuration tool
Hide thumbs
Also See for SINAMICS Series:
- Operating instructions manual (759 pages) ,
- Equipment manual (350 pages) ,
- Function manual (102 pages)
Table of Contents
Advertisement
Installation
3.1
Fitting the IOP
Fitting the IOP to the Control Unit
IOP power supply
The IOP has no internal power supply and derives its power directly from the Control Unit of
the Inverter through the RS232 interface. The IOP can also be connected to a PC and
derives its power through the USB connection.
To fit the IOP to the Inverter Control Unit the following procedure should be performed:
1. Place the bottom edge of the IOP casing into the lower recess of the Control Unit
housing.
2. Push the IOP forward until the top fastening clicks into place on the Control Unit housing.
Figure 3-1
Fitting the IOP to the Control Unit
Intelligent Operator Panel (IOP)
Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB
CAUTION
3
15
Advertisement
Table of Contents
