Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Service Manual
Dell™ Latitude™ XT2 XFR
Setup and Features Information
WARNING:
A WARNING indicates a potential for property damage, personal injury,
or death.
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data
and tells you how to avoid the problem.
NOTE: A NOTE indicates important information that helps you make better use of your
computer.
Front and Right View
20
19
18
17
16
15
14
08/2009
21
13
22
11
12
4FNPNA00
1
2
3
4
5
6
7
8
9
10
Model P05S
Advertisement
Table of Contents
Related Manuals for Dell Latitude XT2 XFR
Summary of Contents for Dell Latitude XT2 XFR
-
Page 1: Front And Right View
Dell™ Latitude™ XT2 XFR Setup and Features Information WARNING: A WARNING indicates a potential for property damage, personal injury, or death. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. - Page 2 ExpressCard slot Secure digital (SD) card slot USB/e-SATA combo connector Wi-Fi Catcher™ button NOTE: Press <Fn><F9> to toggle between WLAN and WWAN. Latitude XT2 XFR does not support simultaneous operation of WLAN and WWAN modes. Wireless radio on/off switch Touch pad...
-
Page 3: Back And Left View
Do not block, push objects into, or allow dust to accumulate in the air vents. Do not store your Dell™ computer in a low-airflow environment, such as a closed briefcase, while it is running. Restricting the airflow can damage the computer or cause a fire. -
Page 4: Bottom View
™ Dell Latitude™ XT2 XFR Setup and Features Information Bottom View Memory access Wireless access Battery & HDD locking latches CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. - Page 5 ™ Dell Latitude™ XT2 XFR Setup and Features Information I/O Door Operation All ports and I/O connectors on the computer are secured behind locking I/O doors. To open the I/O locking doors, use the following procedure. 1. The image below shows the door in its closed and locked position. Lift the door flap.
-
Page 6: Quick Setup
Before you begin any of the procedures in this section, read the safety information that shipped with your computer. For additional safety best practices information, see www.dell.com/regulatory_compliance. WARNING: The AC adapter works with electrical outlets worldwide. However, power connectors and power strips vary among countries. Using an incompatible cable or improperly connecting the cable to the power strip or electrical outlet may cause fire or equipment damage. - Page 7 ™ Dell Latitude™ XT2 XFR Setup and Features Information 2. Connect the network cable. 3. Connect USB devices, such as a mouse or keyboard. 4. Connect IEEE 1394 devices, such as a DVD player. 5. Open the computer display and press the power button to turn on the computer.
-
Page 8: Battery Removal
™ Dell Latitude™ XT2 XFR Setup and Features Information NOTE: It is recommended that you turn on and shut down your computer at least once before you install any cards or connect the computer to a docking device or other external device, such as a printer. - Page 9 ™ Dell Latitude™ XT2 XFR Setup and Features Information 7. While continuing to push the locking latches, slide the battery back approximately .100”. 8. Lift and remove the battery from the computer. Page 9...
-
Page 10: Battery Replacement
™ Dell Latitude™ XT2 XFR Setup and Features Information Battery Replacement 1. Turn the computer upside down, and place on a flat surface. 2. Lift and place the battery into the computer. 3. Then slide the battery in the direction shown in the image below approximately .100”. The battery will lock into place with a click and a mechanical stop. -
Page 11: Hard Disk Drive (Hdd)
™ Dell Latitude™ XT2 XFR Setup and Features Information 4. Push the battery locking latches down into their flat positions. Hard Disk Drive (HDD) Remove a HDD Ensure that the computer is turned off. 2. Turn the computer upside down, and place on a flat surface. - Page 12 ™ Dell Latitude™ XT2 XFR Setup and Features Information 5. Slide the HDD in the direction shown below and lift slightly to remove. Replace a HDD 1. Place the HDD into the battery compartment ensuring that the 4 hooks on the bottom of the HDD align with the 4 slots in the base.
- Page 13 ™ Dell Latitude™ XT2 XFR Setup and Features Information 3. Replace the battery as discussed in the Battery section above. Memory Access Door NOTE: See Service Manual for details on removing and replacing memory. 1. Ensure computer is turned off.
- Page 14 ™ Dell Latitude™ XT2 XFR Setup and Features Information 7. The memory modules will now be accessible. 8. Reverse this procedure to replace and secure the memory access door. Pen/Tether Installation Pen tether anchor Tether The pen and tether are connected to the computer by looping the tether through the tether anchor point.
-
Page 15: Hot Swappable Modules
™ Dell Latitude™ XT2 XFR Setup and Features Information The pen is stored by pushing the pen into the pen garage until it clicks into its locked position. The pen is removed by first pushing in on the pen until it clicks and is released. The pen can then be removed from the pen garage. - Page 16 ™ Dell Latitude™ XT2 XFR Setup and Features Information 3. Insert the hot swappable module (either camera or GPS). Ensure the device is properly seated. 4. Lock the hot swappable module device into place by sliding the lock to the locked position.
- Page 17 ™ Dell Latitude™ XT2 XFR Setup and Features Information Page 17...
-
Page 18: Gps Hardware Configuration
™ Dell Latitude™ XT2 XFR Setup and Features Information GPS Device Follow the directions in the hot swappable modules section above to install the GPS device. Ensure the GPS device is properly seated and the lock is in the locked position. - Page 19 ™ Dell Latitude™ XT2 XFR Setup and Features Information 3. Double-click on “Ports”. Right-click on the USB Serial Port (COM#) device and select Properties. Page 19...
-
Page 20: Software Configuration
™ Dell Latitude™ XT2 XFR Setup and Features Information 4. Select the Port Settings tab. Confirm that the following settings are assigned to each field shown below: Bits per second: 4800 Data bits: 8 Parity: none Stop bits: 1 Flow control: None... - Page 21 ™ Dell Latitude™ XT2 XFR Setup and Features Information 1. Click on the Start button and right-click on Computer; then click on Properties. 2. Click on Device Manager. Page 21...
- Page 22 ™ Dell Latitude™ XT2 XFR Setup and Features Information 3. Double-click on “Imaging Device”, and locate “USB UVC Webcam”. a. If a ‘Yellow Bang” appears on the device, then the drivers should be reinstalled. b. If “USB UVC Webcam” is under Device Manager, but the camera is non-functional, locate the “USB Composite Device”...
-
Page 23: Specifications
Dell Wireless 5530 HSUPA/HSDPA Mobile Broadband1 Minicard, GOBI Hot Swappable Optional GPS Receiver or 2.0MP Camera Module Security Dell ControlVault®, Dell ControlPoint Security ManagerCable lock slot, Integrated Smart Card Reader, Fingerprint Reader, Computrace Option, TPM 1.2 Ergonomics 12.2" x 9.6" x 1.49" Weight Starting at <5.5 lbs... -
Page 24: Finding More Information And Resources
™ Dell Latitude™ XT2 XFR Setup and Features Information Temperature Shock, and Temperature Extremes (Operating: -10ºF to 140ºF (-23ºC to Certification* 60ºC); Non-Operating: -40ºF to 158ºF (-40ºC to 70ºC)) • IP-54 Certified Protection – Level 5 Dust Protection: Ingress of dust does not interfere with the operation of equipment;... - Page 25 Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, Latitude, Dell, Wi-Fi Catcher, and the DELL logo are trademarks of Dell Inc.; Intel is a registered trademark of Intel Corporation in the U.S.