Using Mpegvue/Evue On A Remote Pc - GE Vivid q N Service Manual

Hide thumbs Also See for Vivid q N:

Table of Contents

Using MPEGVue/eVue on a Remote PC

Installing MPEGVue on a Remote PC

For systems running a software version earlier than 6.1.0 (build 109), the MPEGVue player is not

compatible with Internet Explorer 7, therefore, do not upgrade Internet Explorer on your PC to this

version. In the event that an upgrade has already been installed, following the instructions for rolling

back to Internet Explorer 6 on Windows XP provided on the Microsoft site, as follows:

http://www.microsoft.com/windows/ie/support/default.mspx

When a DVD/CD containing MPEGvue exams is placed into a DVD/CD drive on a remote PC, it should

self-boot within a few seconds and display the Patient List.

The first time this is done on the remote PC there will be a one-time operation where the MPEGvue

program will self-install. If the remote PC operating system is Windows XP the installation is automatic

and, when completed, the Patient List on the DVD/CD will be displayed.

In the event that the remote PC operating system is Windows 2000, the auto-installation will display one

of the messages shown below (see

and install some drivers.

The requested drivers may be downloaded from the Internet, or, if the DVD/CD was pre-configured,

those drivers will be located on the MPEGvue DVD/CD itself.

In addition to the above, the installation program will test the configuration of the remote PC and will

display a message if any component on the computer is not within the required specifications.

Only Windows 2000 and later supported.

Figure 3-143 Download/Installation Message Examples #1

Section 3-10 - Connectivity Setup

Figure 3-143

3-144), requesting the user to download

Show Quick Links

Table of Contents