IBM QRadar XGS 5200 Replacement Instructions

Network interface module replacement instructions

Download this manual

Network Interface Module Replacement Instructions

This document helps you to complete the following tasks:

v Remove a failed network interface module and replace it with a new network interface module

v Verify that the replacement network interface module is working correctly

Best practice: Replace a failed network interface module as soon as possible.

Important: Before you proceed with these instructions, review the IBM Systems Safety Notices provided in

the IBM Media Terms and Conditions CD that is included with your appliance model.

Note: The illustrations in this document might differ slightly from your appliance model.

Supported appliances

The instructions in this document support IBM

00VM976).

Replacing a failed network interface module

About this task

Identifying the network interface module

The front panel of the appliance contains the network interface modules, as highlighted in yellow in the

following figure:

Figure 1. Location of the network interface modules on the front of the appliance

Procedure

1. Turn off the appliance by using the local management interface (LMI) or the command-line interface

(CLI).

2. Unplug all of the power cords that are attached to the appliance.

3. Grasp the blue latch on the front of the appliance and pull it toward you.

4. Pull the lever on the failed module toward you, and then pull module from the chassis, as shown in

the following figure:

QRadar

Network Security XGS 5200 (IBM Part Number:

Page 1 Best practice: Replace a failed network interface module as soon as possible. Important: Before you proceed with these instructions, review the IBM Systems Safety Notices provided in the IBM Media Terms and Conditions CD that is included with your appliance model.
Page 2 What to do next Check whether the new module is working correctly by logging in to the appliance LMI and verifying that the new module was recognized by the appliance. IBM Security: Network Interface Module Replacement Instructions for IBM Part Number 00VM976...