IBM Power System LC922 Quick Install Manual
Hide thumbs
Also See for Power System LC922:
- Quick install manual (15 pages) ,
- Quick install manual (20 pages) ,
- Servicing (158 pages)
Advertisement
Quick Links
IBM
Power System LC922
(9006-22P) Quick Install
IBM
Guide
®
®
IBM
Power
System LC922 (9006-22P) Quick Install Guide
The IBM Knowledge Center is available online from: http://www.ibm.com/support/knowledgecenter/
POWER9/p9hdx/9006_22p_landing.htm.
v Read all precautions and instructions before you start working on key parts.
v Use normal electrostatic discharge (ESD) procedures when working on the system and parts. IBM
recommends wearing gloves and an anti-static wrist strap to avoid possible damage to the equipment.
9006-22P parts
Figure 1. Rack final assembly
Advertisement
Related Manuals for IBM Power System LC922
Summary of Contents for IBM Power System LC922
- Page 1 Read all precautions and instructions before you start working on key parts. v Use normal electrostatic discharge (ESD) procedures when working on the system and parts. IBM recommends wearing gloves and an anti-static wrist strap to avoid possible damage to the equipment.
-
Page 2: Rear Ports
Figure 2. System parts Rear ports... -
Page 3: Installing And Removing
Figure 3. Rear ports Table 1. Input and output ports Identifier Description USB 2.0 used for keyboard and mouse. Certain USB drives might be too wide to fit properly into the USB ports on the rear of the system. Test the fit of your USB drive before proceeding. - Page 4 Figure 6. Removing a front drive Figure 7. Removing the 3.5-inch drive from the tray Figure 8. Removing a DOM Figure 9. Removing a rear drive...
- Page 5 Figure 11. Disconnecting the drive signal cables the drive power cables Figure 10. Opening the rear drive tray Figure 13. Disconnecting the drive signal cables the drive power cables from the system backplane Figure 12. Removing the disk drive backplane and screws...
- Page 6 Figure 15. Removing a fan Figure 14. Disconnecting the drive signal cables and the drive power cables from the disk drive backplane Figure 17. Single-processor plugging sequence Figure 16. Removing the memory DIMM Figure 18. 9006-22P PCIe adapter positions Figure 19. Removing the PCIe riser...
- Page 7 Figure 20. Removing an adapter in position 1 from the Figure 21. Removing a position 2 adapter from the riser riser Figure 22. Removing position 1 riser card Figure 24. Removing an adapter from the riser Figure 23. Removing the PCIe riser...
- Page 8 Figure 25. Removing position 3, 5, or 6 riser card Figure 26. Releasing the tail-stock Figure 27. Screw locations Figure 28. Lifting out the system backplane...
- Page 9 Figure 29. Opening the system processor module packaging Figure 30. Loosening the load arm screw of the heat sink Figure 32. Lowering the removal tool onto the system Figure 31. Lifting the heat sink from the load arm processor module...
- Page 10 Figure 34. Lifting the system processor module from the packaging tray Figure 33. Locking the system processor module into the tool Figure 36. Installing the heat sink Figure 35. Installing the system processor module...
- Page 11 Figure 37. Tightening the load arm screw Figure 39. Removing the TPM card Figure 38. Time-of-day battery location...
- Page 12 ™ ™ This May 17, 2018 edition applies to IBM Power Systems servers that contain the POWER9 processor and to all associated models. © Copyright IBM Corporation 2018. US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract...