Advertisement
Quick Links
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and qualified in
pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exists. In
the event no such state or local requirement exists, the maintainer must be a professional with sufficient experience in pool
equipment installation and maintenance so that all of the instructions in this manual can be followed exactly. Before installing
this product, read and follow all warning notices and instructions that accompany this product. Failure to follow warning notices
and instructions may result in property damage, personal injury, or death. Improper installation and/or operation will void
the warranty. Improper installation and/or operation can create unwanted electrical hazard which can cause serious injury,
property damage, or death.
These instructions are to be used with the following Replacement Kits:
R0537600 -- AquaPure and PureLink Tri-Sensor Adapter Installation Kit
WARNING
If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal
injury or death.
This document gives instructions for installing
the Tri-Sensor Adapter on an AquaPure or PureLink
systems.
These instructions were written with safety
as the priority and must be followed exactly. Not
following the written procedure or taking shortcuts may
increase the risk of personal injury. Read through the
instructions completely before starting the procedure.
Before starting the procedure, use the parts lists at
the back of these instructions to identify the parts that
are in your kit.
If any parts are missing from the kit, please
call your local Zodiac distributor for assistance. For
technical assistance, please contact our Technical
Support Department at 1.800.822.7933.
A. Check AquaPure/PureLink Firmware
If the chlorine generator power interface board
firmware is 02110A10, remove the jumper from the
tri-sensor adapter, see Figure 5. All other chlorine
generator power interface board firmwares and AKC13
front boards require the jumper.
Verify the chlorine generator power interface board
firmware.
AquaPure
Tri-Sensor Adapter Installation Kit
and PureLink
®
1. On the AquaPure user interface, press "C" Salinity,
"A" Down and "B" Up buttons at the same time.
The first four sets of two digits shown on the
AquaPure interface is the firmware revision. See
Figure 1.
2. Press "D" to resume normal operation.
Figure 1. AquaPure User Interface
TM
Advertisement
Related Manuals for Zodiac R0537600
Summary of Contents for Zodiac R0537600
- Page 1 These instructions are to be used with the following Replacement Kits: R0537600 -- AquaPure and PureLink Tri-Sensor Adapter Installation Kit WARNING If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
- Page 2 Zodiac ® AquaPure ® and PureLink Page 2 Tri-Sensor Adapter Installation Kit B. Installation of Tri-Sensor Adapter on 5. Connect the tri-sensor adapter 8-pin female connector into the tri-sensor connector on the a Chlorine Generator Power Interface chlorine generator power interface board. See Board Figure 3.
- Page 3 AquaPure ® and PureLink Zodiac ® Tri-Sensor Adapter Installation Kit Page 3 4. For PureLink systems only: 7. Turn ON power to the AquaPure/PureLink systems and circulation pump. For all PureLink systems with AKC13 front D. Calibrate the Tri-Sensor Adapter...
- Page 4 2620 Commerce Way, Vista, CA 92081 1.800.822.7933 | www.ZodiacPoolSystems.com ZODIAC ® is a registered trademark of Zodiac International, S.A.S.U., used under license. All trademarks referenced herein are the property of their respective owners. ©2011 Zodiac Pool Systems, Inc. H0366100 Rev - 1109...